This video show that if you run the tap water for about 30 seconds before you use it you will get much more Hydrogen/Oxygen. The video show tap water before that was done and after. Not only is the cell producing more gas but at less voltage (9volts). John AArons (hydrogentap.com)
This video shows the 555 pulse chip along with my ideas about the way Meyers system worked. I did this video only for those who might be interested in my point of view; this is not a video for those that know everything about everything. John AArons "hydrogentap.com"
This is the HydrogenTap with audio description. This is a test to see if you can make a Hydrogen on demand using tap water. This Hydrogen system is very easy to make and maintain. The construction of a Hydrogen on demand will be completed upon these tests.
Electricity Moves over a wire, not through it. In this video I have a picture of "something moving over a field". All power stops but the "Electricity" didn't. Check this out. "THIS IS NOT A SPARK". TELL ME...WHAT IS IT?
The video was made to inspect the Series 3 Plate system after 8 hours running in the car. The Plate used 30 amps of power at 12 volts. The video shows close views of the electrodes and plates."hydrogentap. com"
This is the complete description of the Hydrogen Tap 1 device. This is a Hydrogen on demand device that produces hydrogen from tap water. I have found many type projects out there with one thing in common, that is they all are complicated. This is the first test of one cell that will be installed into a device to run my car.
This video show the new Cell that allows you to make any plate into a Neutral Plate along with the ability to change the plates to the charge (+)(-). The cell also can turn off one side.
This video shows the use of a 12volt Ac to pulse the system. This is the last in a 4 part test that will be followed by using a higher output voltage and a plate system using the 3LR1000 system.See "hydrogentap.com" for stills.
This video shows the "AAron's Cell" running without connection to the battery. The Hydrogen coming from the cell is only a few bubbles but still there. This video is not made to show off the Cell but only as a point of interest. The Cell was not used before the test.
This test is being performed on the new 12 plate system. Each plate is being separated by two nonconductive washers hocked positive negative alternately. The test shows how putting the plates in "hot water" than in cold water lowers the amount of power (amps) required to run the unit. The plates are 5 ½ inch by 3 inches and the test is being run on one 12 volt battery.